GE DBVH512GFWW Dryer "power button control board" Questions

control board at P1 connector. Disconnect the power cord from the power source. Disconnect P3 and P4 connectors from the machine control board and then reconnect them. Disconnect P1 connector and then

...button There is no reset button on this machine, by turning off the power for about 2 to 3 minutes the memory on the control board will clear. Failing this, there is a problem on this control

...power button? If so plug the unit in and try to press and hold it for 5 seconds and see if then it powers on. I suppose you mean no light in the control panel? Or did it fall off? If the harnesses to ...

...power to the main control board - however there is a red light that will flash, replaced thermol fuse, main control board, control board behind the start button- (2) - replaced - hi limit behind the ...

...button is working properly, the issue may be with the control board. The control board is responsible for sending power to the various components of the dryer, including the motor. If the control ...

...power button which was broke off. Compare button to all other buttons on panel to see how they are attached to panel. My husband used Plumbers Goop from Lowes store to attached power button like the ...

...power on button and the pause button at the same time some times it will start and run and sometimes I may have to push it repeatedly to get it to start. Have you seen this problem and do you have a ...

...power to the control board. I press on and nothing shows up. I have checked the door switch/button and the thermal fuse and those seem to be working. Any thoughts on what may be causing this? check ...

...power button You will need to replace the whole control board interface since the button is part of that assembly. Here is the part to order. I had a similar problems with the power button. Turns out ...

...power board also known as the electronic control board has gone bad and needs replacement. As pressing buttons doesn't work then first unplug the unit for 15 minutes and then check, if this does not ...