...electrical tape around edge of new battery, solder on the leads, solder leades on circuit board. Remember which side was up before soldier, close unit, you should be good to go. Georgevb., Had the ...
...electrical contacts to separate when the unit would be turned for viewing. I intend to pay more attention to the battery charge indicator so that maybe I can solve a similar problem in the future ...
Question about Garmin GPS
...Battery acid conducts electricity and must be removed. Anywhere it is results in changes in the values of components and can cause a great deal of problems. You may also be able to exchange for a ...
problems Check to see that the "tip" of the Garmin Car Charger (the end that plugs into the car's cigarette recepticle) is still there. The "tip" screws into the Garmin Charger and can come out. If it
...electrical problem ???? GPS SYSTEMS HAVE A TENDENCY TO LOSE CONNECTIVITY TO SATILLITES BECAUSE OF BAD WEATHER, CLOUD COVER, TUNNEL ENTRANCE, BAD OR NO POWER, BATTERY LIFE HAS BEEN EXPENDED, HAZARD OF ...
...battery.My wife's was always powering off during runs. Then it would not power on at all. There was a connection inside that wasn't making contact. But first First try cleaning the 4 brass connection ...
...Electrical connection3. Remove the Four Small Philips screws on the outside of the case to access the battery and electronics compartment. Very Carefully Disconnect the white battery connector from ...
electrical tape. Connect the brown wire on the Viper 5000 car alarm, identified as H1/3. Connect the brown wire directly to the red wire on the Avenger siren and mount the siren under the hood of your
120 questions posted
Usually answered in minutes!
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions
690 Questions