HP PL4260N 42 in. Plasma HDTV "voltage adjustment" Questions

v scan voltage just started showing an area towards the upper left corner of blue snowy pixel patches. How do i adjust vscan voltage Try to adjust the V scan voltage down about 5-10V. If still not ...

...voltage adjustment how do i adjust the v-scan voltage on a hp-r5052 smasung If you adjust v-scan make sure you adjust it for the setting that is marked on the panel when you take the back off. Why do ...

...when the moving pattern has progressed to the left side of the screen. You need to adjust the panel voltages, adjust the VS voltage to around 186 volts, if that doesn't change it then adjust the ...

...VS adjustment potentiometer. adjust the voltage down at least 10 volts, if your not an experienced person in electronics, get a person that is, there is a high voltage on that board that is ...

...voltage setting. You can reference this sticker to make the proper adjustment. Using a DMM, connected between chassis ground and the panel voltage you are adjusting, turn the adjustments on the ...

...I think it cause by vs voltage is high. You can try to decrease the Vs voltage a little bit. You can adjust the voltage while the TV is on. The Vs voltage adjustment is locate in the power

adjustment that must be done to correct this problem. This adjust is done on the power supply. There are VS, VE and VA adjust. Look on the interior of the Panel for voltage chart. Adjust these voltage

...what could have caused this as it is only 4 mths old? Thanks Phil This is usually caused by an over voltage on one of the panel voltages, if you open up the set and look at the panel you will find a ...

...voltage on the board but it doesnt have a vs adjustment on it so i need some one to help me figure out hot to adjust it so i can get rid of purple/pink band please some one help It will be best to ...

...voltage adjustment. If you can't adjust it to proper value as suggested, the main power supply board need replacement. Even after replaced it with a new board, this adjustment should be done again. ...