...on batt. or drill,take off battery and see if prongs wiggle with your finger.had problem before was trigger though.voids warrenty if you take apart to try to fix.Very hard to put back together ...
...trigger and see if the tool runs. If so, you've fixe it and can put the drill back together. If the wires are good, then it's the trigger assembly and you'll have to get one from either a DeWalt ...
...trigger the motor runs but not the anvil? Sounds like you have a gear broke that runs from the motor to the shaft. Take it apart and check it out. easy to put back together. atleast you will know for ...
...back together and grease the moving parts if needed. Attach a charged battery and pull the trigger in foreward and reverse positions to see if the drill works ok. Mine works like a charm now. One of ...
...trigger and see if the tool runs. If so, you've fixed it and can put the drill back together. If the wires are good, then it's the trigger assembly and you'll have to get one from either a DeWalt ...
...put it in the repaired driver i pull the trigger and the led light comes on but the drill cliks and turns about 1/4 turn then stops, i can pull the battery out put it in another drill and same thing ...
...back into the transmission. If you have a piece of duct tape handy, I suggest putting it over the transmission so you don't hit it accidentally and send small gears flying. ( I have done this on ...
180 questions posted
Usually answered in minutes!
227 Questions
118 Questions
74 Questions
36 Questions