my liftmaster 976 remote entry is eating batteries; they last barely a week and then stop working... the remote is about 10 years old. is there a problem here? Your keypad is going bad. Replace it.
Question about Sears LiftMaster Building Materials
10 years old - instructions tossed. Locate the smart/learn button on the rear of the motor unit near where all those white wires go. Press and immediately release this and then walk over to the keypad
Question about Sears LiftMaster Building Materials
...one works fine, red learn button don't recognise the other. battery checks 3 volts. will a chamberlin # 13953681b work. liftmaster is over 10 years old and is a security+ Should work with no
...Door slides also when disconnected. Tried to tighten chain and got worse. 10 years old. Take a good look at your door springs. Sounds like one may be broken. Have you tried raising the door
Question about Sears LiftMaster Building Materials
...iswhisper drive model940D-01 this has not worked prperly for 2 mos.it is only 10 mos old the last one was chain drive an lasted 12 years cliff It is really difficult to repair a not operate
Question about Sears LiftMaster Building Materials
...10 years old. You may have more than one problem. If it is the main light that is blinking when the opener stops and it blinks 10 times you have a door sensor problem. I think you also need to remove ...
...year before failing. Opener can be closed by pressing only the ENTER button if the One Button Close feature has been activated. This feature has been activated at the factory. To activate or ...
Question about Sears LiftMaster Building Materials
...10 years old On the rear of your motor unit just to the left of all those white wires you will find the smart/learn button. Press and immediately release this and then key in your new four digit PIN ...
Question about Sears LiftMaster Building Materials
10 years old. No problems when using the one handheld remote we were given or the wall control; however, when trying to open/close the door with our cars (we programmed in) or a keypad we installed on
...10 YEARS OLD. IT IS PLUGED TO AN ELECTRIC OUTLET AND I HAVE TRIED CHANGING THE OUTLETS TO NO AVAIL Check to make sure your door sensors are properly aligned. They each have a small light and both ...
5,971 questions posted
Usually answered in minutes!
0 Questions
