Technics SL-1200MK2 Turntable "1200 pitch replace" Questions

...1200 the pitch slider is very hard to move up and down. I really have to push it. Also the pitch doesn't stay constant it moves up and down. Please responsd [email protected] You more than likely ...

...1200 by sight Put the pitch slider to +6 and adjust the internal preset until the top set of dots on the platter are stationary. Check again with the pitch at +3.3 if the dots are stationary then job ...

...1200 The pitch slider is very hard to slide up and down I have to really push it. When I use the turntable the pitch bounces back and forth it doesn't stay still. Please advise You have to have the ...

...pitch on a technics 1200 turntable Take off the platter by pulling up on the 2 holes under the slip matts. Flip it over. Twist off the feet. Take out about a thousand screws. And the black ruberish ...

...1200 mkII. When I set them both to 0 pitch, they're fine.. but when I set them both to lets say 2+ 4+ 6+ etc. they will both be on the same tempo, but one turntable's pitch is MUCH higher (alvin and ...

...1200 mk2 pitch is wobbly when set on center 0 it is fine but when adjusted to any faster or slower it seems to just wobble around like the pitch is bending up n down Hi, remove it and give the ...

...pitch fader in both technics 1200 mk2 turntables, calibrated the faders to 2.70, adjusted the pitch parameter, and one of my turntables is still having a problem with pitch on one of my turntables. ...

...accurate i think it may be damp but it is not working at all what do i need to do to fix it the pitch control slide potentiometer needs to be replaced. This is a common failure on the sl-1200

...1200 Rotates Out Of Control. What needs To Be Done To Fix? It sounds like you need to replace the belt. If it's too loose, it will not maintain the proper speed. your pitch control is worn out,buy a ...

...1200 turntable and the pitch speeds up and down causing music to sound funny.... You will need to check your belt for wear. Lift felt on platter and check belt tension. It may need replacing. To ...