LG WM0642H Front Load "repair bearing grind noise" Questions

bearing to fail, or the shaft broke loose from the 3 arms of the spider which drives the inner wash tub. Either of those things is $$$ and a lot of work to repair, involving removal of the outer drum,

...noise from the drum motor on my LG WM-3677HW front load All-in one washer dryer. Does someone have a repair manual that I could download? Thanks. My brand new one is doing it only after 1 week. I'm ...

...basket support bearing. Depending on the model, you are looking at a cost of a professional to repair it of around $400+. If you do it yourself, around $200. This is a common failure on LG

repair wasn't worth it. Going to get an Electrolux model. the bearing is part of the rear tub you will need to get a new tub if its shot water from rear seal is bering you may need spin basket as well

...noise and barely, if any spins left then right. Is it the motor, belt, or bearings. Was working just fine earlier today. Do I get this fixed or buy again as this model LG is not barely 3 yrs. old? I ...

...repair. Some models of top-load washers use tub dampening straps to cushion the movement of the tub during the spin cycle. There are four straps attached to the top of the tub and to each corner of ...

...repair. Some models of top-load washers use tub dampening straps to cushion the movement of the tub during the spin cycle. There are four straps attached to the top of the tub and to each corner of ...

...repair. Some models of top-load washers use tub dampening straps to cushion the movement of the tub during the spin cycle. There are four straps attached to the top of the tub and to each corner of ...

...repair. Some models of top-load washers use tub dampening straps to cushion the movement of the tub during the spin cycle. There are four straps attached to the top of the tub and to each corner of ...

repair a lg washer that makes a grinding noise when slowing down from spin cycle The washer was not draining completely or agitating or spinning at all. I did a master reset, and it's working properly