Whirlpool Calypso GVW9959K Top Load Washer "3 second stays" Questions

...stays in the locked position. How can I manually override the locked lid? I have an error code "du" that will not clear. blat, unplug the washer for 30 seconds and plug it back in. Hit the power key ...

control lock stays on control lock light stays on machine will not start i tried unplugging the machine still no result Try holding for 3-5 seconds should unlock controls.

...3 or 4 lights stay on and gives a single beep every second have tried filling by hand it will pump out but wont wash or spin thank you troy happy new year. You will need to replace the RPS sensor. ...

...stays on and I can not program or run washer. I have tried unpluging but did not work. I have looked for reset button but have not found one can you help? Carefully and slowly look for a button, I ...

stays on wont let you do anything Press and hold "end of cycle" button for 3 seconds, on the right side of panel. This is the child lock feature, do it again & it locks. If helped, pl rate me good

...stays lit and the washer won't work. an online suggetion was to hold down the control lock button fro 10s seconds--i can'r find that button ghw9150pw1 its in small print under one of the buttons. I ...

...3 second button and nothing happens. I canceled the wash altogether and started another cycle and it ends at the same place in the rinse cycle and just stays there with the lights blinking and an F2 ...

...ghw9150pwo. Control locked light stays on. I upplagged washer for over 1 hr replugged no fix Press and hold the end of cycle button fo 3 seconds ...

..."control locked" light stays on and none of the cycles will run. Thanks. LB LOOK ON PANEL FOR A PICTURE OF A LOCK OR PADLOCK. THERE SHOULD BE TWO LINES TO TWO BUTTONS. HOLD THE BUTTONS FOR 3 ...

machine powers up,,,than the whole machines powers down Let's see if we can get it into diagnostic mode and check for any fault codes. Make sure the dryer is in standby mode, plugged in with all ...