Question about Washing Machines
...large loads or nylon threads inside switch are stripped you need a new knob,the old knob should pull straight off with a little force and you can check the nylon threads to see if they are
...knob is stripped.how to fix? There is a little white plastic clip holding the knob on behind the knob. Remove the clip and the knob comes off. I use hemostats to pull the clip. Just push on the ...
GE washer selection knob doesn't engage When I pull the inner knob out, it just turns without engaging the inner piece to select a wash cycle. The knob it probably stripped. i would replace.
stopping. Usually, if you pull the knob off of the timer assy, you will see in the that knob a "KNOTCH" that is used to align the knob to the timer. That could have been stripped out. Check that first
...fuse that could have blown? The dial below the knob was basically forced to another setting while the machine was running. Thanks Hernus the timer switch was likely stripped and you need to replace ...
knob spins on the timer, but the flange behind it will activate the controls Something is stripped in there, so I need to replace the knobs and hopefully NOT the timer. Do I just pull the center part?
Question about GE Washing Machines
...knob is not stripped, and can be tightened on the timer stem. Therefore, it appeared the problem had to be the timer. We purchased a new timer from our local service parts at the extremely high price ...
Question about KitchenAid Washing Machines
...knob for the washer is stripped is it easy to repair and how do i remove the broken knob? Use a flat blade screwdriver under the control know to pry it up as you turn the control knob. This should ...
...knob. That's what may be broken or stripped. These are all parts that you can get from a local parts store (check the phone book) and you can do it yourself. Any of those parts should cost less than ...
...If your washer goes through the cycles with the knob off then you have a bad timer knob. I have seen stripped knobs causing the timer to bind up and not advance. Good Luck Appliance ...
505 questions posted
Usually answered in minutes!
9,125 Questions
2,624 Questions
2,038 Questions
1,413 Questions
1,373 Questions