...come loose so just make sure they are connected good. water dispenser not working ice maker works Have you checked the wiring harness on the door? Mine quiet working and the wiring harness was
Question about KitchenAid Refrigerators
...harness goes into the door as possible. There may also be a bit of black electrical tape at the end of the mesh closest to the white plug. Remove that, and you should be able to slide the mesh sleeve ...
...harness leading from the bottom of the door leading to a multi plug right in the front of machine, unplug this. from there i would want to check the individual wires coming from the door. a natural ...
...check to make sure the connections are still tight. Good luck. Turns out that it is a bad wire between the connection at the upper left hinge and the display board. I have replaced the wire and ...
...Check the wiring and connections between the low voltage interface and the main high voltage board. If you are able to unplug the refrigerator and remove the cover over the control board on the back ...
...wiring harness, where the original install, had these wires all bound up in the door and each open/close over the past 35 months, caused these wires to break. or check this site just click HERE hope ...
Question about Dometic Refrigerators
...Either way you need to check the harness for continuity and also verify that there aren't any shorted wires. If the harness checks good, then it is probably a bad upper circuit board (eyebrow
Question about Refrigerators
...check them. The wiring harness disappears into the body of the fridge and I don't see any access. Didn't say what brand this is, side by side etc. It could be a bad thermostat or stuck vent if the ...
Question about Hotpoint Refrigerators
...wiring harness like the one I removed. I checked the heater coils and they are good how do I check the thermostat? If this is a button type thermostat, it should read 0 ohms and when it hits the ...
...Check your wiring. It's possible that the wiring harness isn't fully seated (at the fan in the freezer or the electronic control board) or one of the wires in the harness is broken. If those are okay ...
663 questions posted
Usually answered in minutes!
124 Questions
117 Questions
98 Questions
81 Questions
54 Questions