...connect 4ohm speakers to my 8ohm jvc receiver You must connect two sets of speakers to do this. You must connect them in series. Meaning, you connect the positive of one to the positive (red) on that ...
Question about Technics Audio Players & Recorders
...connect and play X4 Wharfedale Diamond Speakers simultaneously with my Technics SA-GX350 Receiver? The Wharfedale Speakers are rated at 6 ohms impedance. The Maual for the Technics Receiver states ...
...appear to be in parallel so you really shouldn't connect a 4ohm speaker to "B" for example if you already have speakers connected to "A". The combined impedance would be too low for the amp
ohm rated speakers if you are using only speakers"A" or only speakers "B", but can not use 8 ohm speakers if you are using speakers "A" and "B" at the same time. Then they must be 16 ohm speakers. Two
...connect additional speakers to connections at any time!!!!!!!!!!! ONLY ONE can be applied to EACH OUTPUT TERMINAL!!!!!! If the speakers your using are fuse protected check fuses or circuit breakers ...
Question about Yamaha Audio Players & Recorders
ohm speakers (not 4 ohm). Also check if the ohm settings are correctly set in Advanced Setup (in standby press on the front panel STANDBY while holding STRAIGHT button). In this menu check the setting
Question about Optimus Audio Players & Recorders
...connect 6ohm speakers to my STAV3350? Hi , you can connect 6 Ohms speakers to your receiver but you will have to increase the volume due to extra demand from the speaker . This does not arm your ...
connect loads (that is all your speakers are to the amplifier); Assume that the speaker outputs are marked + (plus) and - (minus). Series - if you connect a + to a - which is then further connected to
Question about Audio Players & Recorders
...the mixer can provide, connect the "Master Out" or "Mono Out" connections (next to the speaker output jacks) to an external power amp. Connect additional speakers to this external amp and you're
...connect 4 ohms speakers on the AVR 230? Thanks Hello Output impedence of 95% of Herman Kardon sets are desighed for 6 Ohms speaker. There is an output speaker sensor circutary it it which sense the ...
110 questions posted
Usually answered in minutes!
415 Questions
267 Questions
266 Questions
180 Questions
148 Questions