2008 Chevrolet Chevrolet Cobalt LT "replaced starter blowing fuses" Questions

...replaced stater, now fuse @ 59 (15a) blows when pos termal is hooked up to batt. Removed starter hook ups from starter, fuse continues to blow no matter what. I am assuming the fuse was not an issue ...

...blowing 5 amp starter fuse, I changed starter about 6 months ago and it quit , now it has started blowing it again. Only sometimes. Will start when I jump starter if fuse blows.it has always been ...

...replaced my starter and now when I start my vehicle it blows fuse IGE E 10A. The blinkers go out, the AC goes out, the left break light goes out, the RPM needle bounces up and down and when stopped ...

...blowing, had to replace the starter, (it was pulling 80amps instead or the normal 30-35) once the starter was replaced, no more starting issues and the fuse no longer blows. Hope this helps, good ...

...Starter 50AMP fuse is the only one that is blowing. Run a jumper from the fuse connection to the starter There is a pattern failure on that vehicle for starter solenoids spiking on initial crank and ...

...BLOWING 15 AMP START FUSE the starter is the most often cause of the failure the solonoid gets shorted and blows the fuse replacing the starter should fix it, i have also seen a couple of wires for ...

fuses are not cheap.I had replace the starter and it was the same. It was blowing the mist expensive fuse.I end up taking the starter halfway out tighten the but on the ground wiring and that fixed it

...blowing car wont start. car lights up in all other areas just not start and fuse blows everytime I replace it. It is the starter fuse, but does it mean bad starter? means dead short in the wiring to ...

...you are using the proper fuse. If so, disconnect the starter solenoid and then try to start the vehicle. If the fuse does not blow, the starter solenoid (entire starter, actually) should be

...fuses and checked starter.. Starters will still work when worn but will have increased drag drewing too many amps. which will blow your fuses. before replacing older starter first remove all wire ...