Question about Frigidaire Washing Machines
cuts off at 7 minutesleft and will not do the final spin cycle, Model #GLTF2940ES3, Frigidaire Gallery Front Load. It be the carbon brushes are worn down on the motor, when it goes into the final spin
Question about Frigidaire Washing Machines
...GLTF2940ES3 WILL NOT SPIN AT END OF CYCLE http://www.applianceblog.com/mainforums/frigidaire-electrolux/25178-fixed-gltf2940-washer-wont-spin.html this seems to be a common issue, here's the ...
Question about Frigidaire Washing Machines
GLTF2940ES3 - Frigidaire Front load washing machine e59 error code Washing blankets, heard a lot of banging. cycle ended up getting stuck on with 1 minute left. Managed to get door open, pulled ...
...gltf2940es3 dont go into spin this will not spin when set on pump/spin the timer shows 13 mins it pumps out till timer shows 9 mins then tub makes 2 or 3 rounds clockwise then the same the other way ...
Question about Frigidaire Washing Machines
...spin... I have a GLTF2940ES3 front loader. It is a bit over a year old. Today we went to take the clothes out and they were soaked. We tried running drain/spin, rinse/spin...nothing. It does ...
...GLTF2940ES3 Past few loads have been sopping wet when I go to remove them from the washer. I did a check and get E47 as an error code. Also noticed that when I did a drain/spin cycle and it was on ...
...spin GLTF2940ES3 frigidaire front load wont high spin every thing else works either a bad motor control board or your coin catcher is full of stuff. i would check the coin catcher first. open the ...
Question about Frigidaire Washing Machines
...spin... I have a GLTF2940ES3 front loader. It is a bit over a year old. Today we went to take the clothes out and they were soaked. We tried running drain/spin, rinse/spin...nothing. It does ...
...GLTF2940ES3. Cycle ended prior to spin segment. Checked error code history to find E47 fault. Troubleshot per manual. Found that the "PTC one-spot check" read ~1582ohms. Although the book indicates ...
...GLTF2940ES3 is displaying error code E20 and does not spin. I read that it may be a problem with the coin trap being clogged, but I cant open the front access panel. Is it on a hinge or do i need to ...
1,216 questions posted
Usually answered in minutes!
2,660 Questions
1,146 Questions
650 Questions
256 Questions
168 Questions