Question about Shure Audio Players & Recorders
what are the true xlr connection numbers for bottom blue and red wires Blue wire connects to XLR pin 2. Red wire connects to XLR pin 3. You can find a wiring diagram on Shure's website.
Question about Samson Audio Players & Recorders
need the wiring schematic from headset mic to vt2l belt pack mini need wiring diagram for head set mic to mini xlr plug into belt pack mini xlr 1 gnd 2 signal 3 +vcc connect r 1k betwenn 2/3
Question about Audio Technica Audio Players & Recorders
...2 of the XLR and the sleeve of the 1/4" jack to pins 1 and 3 of the XLR should work. The XLR should be plugged into a device that accepts line level. Ideally, you should plug the 1/4" into a 1/4" or ...
...wiring sequence to use a sennheiser Me66/k6 on a Canon Xl-1s. That is from the K6 XLR output into the XLR input on the Canon M100 adapter that in turn feeds into Audio One inpot Thanks Chris Owen on ...
Question about Behringer Audio Players & Recorders
...on. The same connections can be veiwed in the user manual here Please rate this solution. Cheers regards robotek If its an xlr plug , Black/Earth to pin 1 , Red to pin 2, white to pin 3 Best of ...
Question about Shure Audio Players & Recorders
...xlr should pull out....the wiring is as follows.. Green- Pin 3 yellow- Pin 2 and there is no ground wire but make sure the metal tab go inside and makes contact with the body of the mic and is ...
the 1/8 inch plug and pin 2 of the XLR connector to BOTH the tip and ring of the little stereo jack. Such a cable is not commonly available so the best is to make one from parts you get at Radio Shack
...XLR plugs and check: Pin 1 shield Pin 2 hot (usually red wire) Pin 3 cold (black, blue or whatever) Pinnumbers are written near pins usually. If that doesn't help shake the cable for contact ...
...wiring diagram for 1x3pin xlr plug to 2x3pin xlr female plugs.microphone splitter. Pin 1= ground/shield, Pin 2= hot(+ve), Pin 3= cold(-ve). Just remember if you make a cord like this you can expect ...
Question about SE Electronics Audio Players & Recorders
...z3300a It uses a standard balanced XLR wiring which is 1= ground/shield, 2= (+ve) hot and 3 is (-ve) cold. Do not bridge pins 1 and 3 as this mike uses phantom power. Please let me know if this
24 questions posted
Usually answered in minutes!
147 Questions
75 Questions
14 Questions
12 Questions