...Zero-cross signal error,While fuser heater ON/OFF control is performed, the zero-cross signal is not input within 3 s. The problem is; Defective PWB, replace the engine PWB or power source PWB and ...
Zero cross signal error While fuser heater ON/OFF control is performed, the zero-cross signal is not input within 3 s. Causes: - Defective the power source PWB. - Defective the engine/high voltage PWB
Question about Kyocera FS Office Equipment & Supplies
...Error C6400 appears in Kyocera FS118 when Zero crossing signal problem occurs i.e when the engine PWB doesnt detect the zero crossing signal. This can occur due to -- #1 Poor contact in the connector ...
...zero cross signal error) but we see this being the power supply and/or bad power to the unit. Check your power outlet (it should be on a separate or dedicated plug with no other devices). Remove and ...
zero cross signal error)but we see this being the power supply and/or bad power to the unit. Check your power outlet (it should be on a separate or dedicated plug with no other devices). Remove and re
Question about Kyocera FS Office Equipment & Supplies
...Zero cross error. Could be the power source PWB or the control PWB bad. reset the fuser code 6400 by pressing counter/system button, then go to service setting, then hold the start and hash button at ...
...attached image from service manual. Link to wikiredia RE: zero crossing signal: http://en.wikipedia.org/wiki/Zero_crossing When I got this error I just went into the maintenance mode and executed ...
Question about Kyocera FS Office Equipment & Supplies
Zero Cross Error When the power switch is turned on. The machine checks how many Zero-cross signals are generated during 500 ms. If the number of Zero-cross signals is more than 66 or less than 45 and
Question about Kyocera Office Equipment & Supplies
...error code c6400 Zero-crossing signal problem • The engine PWB does not detect the zero-crossing signal for the time specified below. At power-on: 3 s Others: 5 s Causes: - Poor contact in the ...
Question about Kyocera FS Office Equipment & Supplies
Zero Cross Error When the power switch is turned on. The machine checks how many Zero-cross signals are generated during 500 ms. If the number of Zero-cross signals is more than 66 or less than 45 and
97 questions posted
Usually answered in minutes!
192 Questions
143 Questions
118 Questions
97 Questions
55 Questions
