KitchenAid Artisan Series Tilt-Head Stand Mixer "mixer lock down" Questions

...mixer head is down and locked in place the safety lock, Im assuming wont disengage. I can not turn the mixer on. If this is a 325 watt Artisan, there is no safety switch I know of unless its in the ...

...mixer gets locked down. Turn on. Arm jumps up and down. Even on low speed. that mixer has two different beaters one for next to the outside of the bowl and one for the center of the bowl if you get ...

...mixer lock switch. There are several really good videos on youtube that shows step by step procedure for taking the mixer apart. you will see the switch when you have the mixer apart. tighten the ...

...Mixer Bowl Lock Plate 4163032 and the KitchenAid 5 Quart Stainless Steel Bowl work on yours which would require a modification of the bowl lock plate or replace the mixer. - Colleen @ Mending ...

...lock the mixer head down, as required to set beater speed. this tilt-head models' motor head locking levershifts about3/4's of the way and then stops, i've checked the manual in case i was forgetting ...

...mixer attachment I belive you must press up on the attachment to lock the inside gear into place. Once it is locked into position you can now twist to the left to remove the attachment. once removed ...

...mixer head is jumping up and down while mixing it has even worn the white off the beater. while off you can actually have the mixer locked and you can move the head up and down in locked position. ...

...mixer. I can lock and unlock the arm up and down, but I can not get it to turn on. I did confirm the arm was in the lock postition, but when I try to turn it on, it will not budge from the off ...

...lock mechanism has one additional adjustment hole. You have to disassemble the mixer. I recommend returning it if you can. If not, see my posts on "removing the motor cover" and that adjustment must ...

...lock just wasn't engaging with a slot in the base of the mixer. Try lifting up the head of the mixer to expose the height adjust screw in the hinge between the base and the head. By tightening mine ...