KitchenAid Artisan Series Tilt-Head Stand Mixer "screws side kitchenaide mixer" Questions

...screws (two on each side) holding on the top cover for the mixer. Remove the four screws and then lift off the top cover and you'll see the motor, circuit board and gear box that operate the

...mixer as it tries to mix your dough is that the head unit is thrust back and forth and side to side (bucking). Eventually hinges become loose and sloppy. Kitchenaid's behaviour is legal and beyond ...

...screws on either side of the head of the unit, each above the locking mechanism on one side and the speed control knob on the other side. When I removed these, I noticed that they had copper coils ...

...SIDE IS COOKED AND WONT COME OUT BRUSH IS LIKE POWDER AND WANT TO KNOW HOW TO GET TO IT AND GET IT OUT I TOOK THE BACK CUP OFF AND THE 4 SCREWS ON THE BOTTOM OF THE HOUSING WHAT NEXT? Hi. Before you ...

...screws on the side of my KitchenAid mixer and out sprung a spring and magnet. When I replacter them my mixer won't start... It sounds like you removed the brushes, look in the hole and determine the ...

...screws. Carefully remove them paying attention to the motor brush keyed position.You will see that one side is keyed.Check to see if the brush is competely worn down,or possibly cracked ( replace ...

side screws Not near enough info to solve this one. What happened last time you used it, have you checked the wall outlet (yes I know but still check it) next it could be your power cord for the mixer

...do it myself? Mary i called kitchenaid. and i am repaired. lay mixer on its side. then you can see how rod needs to line up. loosten screw a bit if necessary. then tighten back up. very easy

mixer (325 watts/model KSM150), about 5 years old. Lately, when mixing dough for bread or cookies, the motor head of the machine wobbles a bit from side to side. In addition the pin on the side starts

Remove all screws from bottom side of gearcase, 5 around planetaty, 2 in the middle and 2 at the back. You can now seaparate the gearcases to get to the speed control lever which is held on by 1 screw