Question about Mercedes-Benz ML320
...turn the ignition to the crank position and the light should light while you are still touching the small post. This will tell you that everything is working as it should and that your starter is not ...
...turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done. The turn signal switch is called a multifunction switch. The ...
...turn signal lamps are OK... flasher unit is suspect. How do I remove and replace flasher unit? these vehicles do not have flashers, it is the turn signal switch in the steering column it is called a ...
...turn signal relay. You can get to the switch by removing the radio and reaching behind the dash. To remove the radio there is a plastic trim around the climate controls and radio, This needs to ...
...turn signal switch out what tools do i need to get the turn signal switch out of the steering column of a 2000 saturn Impact gun. Steering wheel puller lock plate removal tool screwdrivers 1/4 socket ...
...turn signal stalk Early 2000 eclipses: Remove two philips screws bolting the signal stalk base to the column Late 2000 eclipses: Squeeze the top and bottom release levers to release the signal stalk ...
...remove turn signal wire harness New turn signal New set will have a plug on it so don't be concerned about just cutting the plug off to get the old harness out. You have to remove the steering wheel ...
Question about Mercedes-Benz ML320
...turn signal relay. You can get to the switch by removing the radio and reaching behind the dash. To remove the radio there is a plastic trim around the climate controls and radio, This needs to ...
...turn signal switch is located on the left hand side of the steering column. You have to remove the air bag (be aware, if you remove the air bag incorrectly, it could activate and cause an injury) and ...
Question about Volkswagen Cars & Trucks
...signal switch. It will need replacing so you will need to remove the four star headed screws holding the panel the hazard switch is in. (2 underneath and 2 on the front). Two of the screws are hidden ...
466 questions posted
Usually answered in minutes!
630 Questions
563 Questions
615 Questions
474 Questions
420 Questions