2007 Chrysler 300c AWD Sedan New Cars "oxygen sensor resistance check jeep" Questions

Ad

...Oxygen O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2) Essentially the same as P0136, P0137 refers to the second oxygen sensor on Bank 1. P0137 means the O2 oxygen sensor's voltage remained low for ...

Ad

...There is no ballast resistor on this Jeep. Check your oxygen sensor. Mine was doing the same thing. Replaced everything you did and more. After replacing the oxygen sensor it ran nicely! Good

Ad

Question about Chrysler 300C

2 Answers

...oxygen sensor (HO2S) 1 , bank 1 , heater control -circuit malfunction Possible causes: Fuse, wiring, HO2S, ECM Steps to repair: check fuses and connector to O2 sensors (at the bottom of exhaust ...

Question about Chrysler 300C

1 Answer

...sensor, new plugs , new cap & Rotor, new wires, has electrical cut in / out of engine run, drop of tachometer 100/400 RPM, now the kicker, doesn't do it all the time, or at any particular ...

...oxygen sensor on bank 1 decreases time needed to enter closed loop. As the O2 heater reaches operating temperature, the oxygen sensor responds by switching according to oxygen content of the exhaust ...

...oxygen sensor in the exhaust...since this started after we submerged the jeep in some deep muddy water on our last off roading trip...... Possible...Check output with a good digital volt/ohm meter. ...

Question about Chrysler 300C

1 Answer

...PCM? for p0135, you can try this: Repair short or open or high resistance in wiring harness or harness connectors Replace oxygen sensor (cannot repair open or short that occurs internally to

...oxygen sensor is bad. or the wires to it are broken (snapped or melted or corroded) a tech, checks that power reaches those wires. inspects them. then measure the heater pins , (resistance) is about ...

...Oxygen sensor? Idle Control Valve? Heat related resistance build up of some electronic component? I would start with cleaning the throttle bore and plate. Then clean the Idle Air Control valve, IAC, ...

oxygen sensor in the exhaust down pipe. Removed, cleaned and ohm tested the Intake Air Temperature sensor which checked correctly for resistance New coil I'm not at all sure what to do next. As I say,

Not finding what you are looking for?
2007 Chrysler 300c AWD Sedan New Cars Logo

265 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...