2007 Ford Crown Victoria LX Sedan "2001 vic police" Questions

...2001 police Crown vic it was the crank shaft position sensor. A $20 part and about 30 mins to put it in. located near the bottom of the engine. I had to un bolt the A/C compressor and push it out of ...

...2001 crown vic police interceptor, when im driving the motor is acting real sluggish and when I go to accelerate from 40 to 55 it jumps real bad and on the engine code it always says cylinder 5 ...

...Vic Police Interceptor Can't figure out if or how to lay down the backseat The backseats of this vehicle do not fold down. They are placed on hooks and then they're bolted in on the bottom right and ...

...vic police. Had check engine light with misfire code to cyl 3, 6, 7, 8. Changed plugs and new coil packs. The car still shows misfire codes and still runs bad. Any ideas? your egr on that side is ...

...vic 4.6L No police package! well if you have checked the spark plugs and they look good then its probly the coil If the plugs have never been replaced i would start with a tune up and see if this ...

...2001 Crown Vic Police Interceptor has a heating issue. The air will not blow for some time. It seems to kick on after it warms up. Also, after the air is blowing, it seems to be at a lower output. I ...

2001 CROWN VIC POLICE...DRIVING WHEN THE TEMPUTURE SENSOR ON THE INTAKE MANIFOLD BLEW OUT AND WATER WENT EVERYWHERE...FORD SAID MY MODEL WAS NOT IN THE RE-CALL IT IS A PLASTIC MANIFOLD...THANK YOU yes

2001 crown vic police..tempature sensor blew out of the intake manifold....I used JB WELD and put it back in and its holding...what could of caused this to happen? I thought there was only 15psi ...

fuel pump not working need a diagram for a 2001 crown vic police interceptor on droping a fuel tank so i can replace the fuel pump !!

...2001 ford Crown Vic LS, Codes read: (p0720 output speed sensor circuit), & (p1131 lack of heated oxygen sensor bank 1 sensor 1 switch indicates lean)........Keep in mined that I just swapped ...