Question about Chevrolet Silverado 1500
read code then delete codes,,with no check engine light on it will crank with remote start ,,a few times,,,,or til the light reappears ,,,you can also take the neg cable off the battery for 30 seconds
Question about Chevrolet Silverado 1500
...to read the code and clear it. no such thing as a check engine light reset. go to your auto parts store, ask them if they can pull the code or codes from the computer, then post the code or
trouble codes read. Most parts stores provide this service for free. They can recommend what should be done to fix the problem after they scan for codes. Any further info needed, u can post any ? here
...CHECK ENGINE LIGHT CAME ON I TOOK AND HAD THE CODE READ P0060 SENSOR 2 BANK 2 OUT SO I REPLACED THE LIGHT STAYS ON EVEN AFTER IT WAS RESET AND SAME CODE COMES UP Did you change all the O2 sensors on ...
...check engine light stay on. what could be the cause? where is the sensor for the engine located? There are a vast arraqy of possible causes. You need to go to the local parts store and have a code ...
...check engine light came on after my engine started overheating. I did a diagnostic reading on it and the code came up P1258. What does that entail? code po 1258 is an overheating code, need to check ...
...check is a bad injector if engine seems to run ok also a missfire in ignition system but that will cause engine to shake run rough we will need to find out what code is regestered take the truck to a ...
Question about Chevrolet Silverado 1500
...Read Our Article On Oxygen Sensor Codes For Help With This Generic Check Engine Light Code P0174 System too Lean (Bank 2) - Read Our Article On Oxygen Sensor Codes For Help With This Generic Check ...
...codes are then go from there with repairs. Diagnosing a trouble light without the code is impossible, you will need to have the code read. Once you get it read, if you have any questions about how to ...
check engine light came on and this morning it was still on, I disconnected the battery, checked all fluids and the light was still on. I checked a few electrical connections to see if they were tight
333 questions posted
Usually answered in minutes!
4,236 Questions
159 Questions
130 Questions
67 Questions
56 Questions