2007 Honda Ridgeline "changing tension pulley" Questions

...pulley; release tension from belt; remove belt; make sure not to forget how the belt is routed; route belt around all pulleys but tensioner; put tension on tensioner pulley; route belt over tensioner ...

...pulley Belt Tensioner Automatic tensioners are calibrated to provide the correct amount of tension to the belt for a given accessory drive system. Unless a spring or damping band within the tensioner ...

...pulley what sets the tension on the serpentine belt yes and that's how you change the belt also. just turn it with a wrench to loosen it if you want to change the belt. The adjustment should be done ...

...start troubleshooting the problem. REPLACE THE TENSIONER IDLER PULLEY.THE TENSIONER IDLER PULLEY MAINTAINS THE BELT TENSION WHEN IT GOES BAD.THAT WILL LEAD TO LOOSE BELT TENSION CAUSING BELT TO

...Changing a belt on a 2006 Grand Prix GT 3800 series 3 supercharged engine can be a bit of a challenging task. Here are the steps you can follow to change the belt: First, open the hood and locate the ...

...as the old one (your sketch should be your reference) remove tension on the tensioner pulley as before to get the belt over the last pulley which should be the small diameter alternator

the various pulley grooves on the pulley system. 6 Release the tension pulley bolt, and apply tension to the belt. The auto-tensioner will automatically apply the correct amount of tension on the belt

...tension, then remove the drive belt. To install: Install drive belt (A). Route the belt over the components in the following order: Crankshaft pulley → A/C pulley → idler pulley ...

change a serpentine belt on a 97 lincoln 3.8L EngineInsert a 1/2 inch flex handle in the square hole in the tensioner. The tensioner has a square hole cast into the rear of the tensioner body directly

...pulley to take the tension off the belt. Slide the belt off and then install the new one using the diagram under the hood as a guide. Check this thread for some photos: ...