2005 Ford Mustang "removing glass front window regulator" Questions

...removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component. Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 ...

...glass. Disconnect the front door window regulator motor electrical connector. Remove the equalizer bracket nuts. Fig. Remove the equalizer bracket nuts-2005 Explorer Sport-Trac Remove the front door ...

...glass. Adjust front door window glass as described. Install front door trim shield and front door trim panel. Refer to Section 01-05 There is a ball on the cable somewhere. run the cable up and down ...

...front door window glass as described in this section. Remove two nut and washer assemblies attaching the equalizer bracket. Remove three rivets (manual) or four rivets (power) attaching the regulator ...

...Glass ? Front Printable View (328 KB) Special Tool(s) Heavy Duty Riveter 501-D011 (D80L-23200-A) Remove the front door trim panel. For additional information, refer to Section 501-01 . Position the ...

...front door window glass in the full upward position with tape. Remove the front door window glass-to-regulator assembly bolts. Loosen the glass clamp fasteners through the 2 vertical slots in the ...

...front door window glass to the full up position. Disconnect the power window motor electrical connector. Remove the window glass to regulator nuts. Remove the motor and window regulator assembly. ...

...front door window glass. For additional information, refer to Front Door Window Glass in this section. Disconnect the front door window regulator motor electrical connector. Remove the window ...

front glass run channel. Remove the nuts attaching the glass channel to regulator arm. Separate the glass and lift it up and out. Disengage the power window motor wire connector from the door harness,

...front window components (window glass, window regulator, window motor and glass top run) must be installed/tightened and adjusted to specification before carrying out this procedure. NOTE: If this ...