...start it again and 5-10 seconds it shuts off again. COULD BE FAULTY IDLE SPEED CONTROL.STOPPED UP FUEL FILTER.STUCK OPEN PVC VALVE OR EGR VALVE.COULD BE DEAD OR BAD PLUG OR PLUGS ALSO FAULTY FUEL ...
it starts but stops in like 5 seconds Are you using a reproduced key. Most Intrepids require a key with a chip in it and they are the only type of key that will start the engine.
start, no spark, no cam reference signal at pcm, has 5 volt supply at cam sensor and ground at cam sensor. I thought it would start with the cam sensor unplugged, it would just have a long crank time.
5 minutes, will wipe out memory and reset problem codes, after you start engine. You will start a new set of any problem codes. P.S. Auto Zone, no charge for Code Reader, a Dealer will charge at least
...5 cyl.rod had spun a bearing. i replaced All the Bearings and 15 min after i started it up it started knocking again. now i runs for 10 mins or so then starts knocking mate u have to get ur crank ...
...start but wouldn't. Ok, I disconnected the cam positioning sensor and the car started and runs. It takes about 5 seconds of cranking because the crankshaft sensor needs to find the signal. The car ...
Question about Dodge Intrepid
5 days and now it will not run anymore. The car has 125,000 miles. Ignition coil, fuel pump causing the problem? Does the engine turn over ? if not then check your battery/charging system....and check
Question about Dodge Intrepid
the battery for 5 mins then rehook and start you cannot adjust timing on the 2.7.The chain links have to be lined up with marks on the gears.if they are not lined up it wont start and will bend valves
...start was most likely caused by the throttle position sensor. There is a variable resistor inside the sensor that sends a signal from 1 volt to 5 volts, and is constantly monitored by the PCM. There ...
1,572 questions posted
Usually answered in minutes!
867 Questions
924 Questions
766 Questions
627 Questions
548 Questions