2001 Ford Escort ZX2 "car wont drive standard transmission" Questions

...blew a part a week ago changed it now transmission wont shift out of first gear all gears work but drive why ? Was it a used transmission out of a junkyard? Is it a standard or an

car goes into drive pulls away then jumps out of gear and wont drive Automatic? Shift linkage bushings bad and need to be replaced. Or, Shift linkage parts are bent or badly worn. Similar issues occur

...wont go into reverse unless the car is off Have a manual transmission, wont go into reverse unless the car is off, shifts fine otherwise, sometimes its a little hard to get it into 1st I've never ...

...drive If automatic transmission wont work engine block's are not the same, if stander transmission you could swap out bell housing held on with four bolt's from one to the other. Good luck and hope ...

****** wont shift to drive,the trans get 1st,2nd,and reverse standard or automatic transmission. and does it do it when driving, or is the shifter bad at a stop.

...drive it the gears grind like they wont shift corectlt I wanna know should I just get a hole new transsmison 4 it or is it the shift solenoid that needs 2 be replaced If it is a standard/manual shift ...

My orthia wont go into gear? i put transmission into reverse drive everything but stays in neutral? auotomatic or standard,? sounds like a mechanical linkage problem. I would start there.

...wont move forward will in reverse Are you driving an automatic? It sounds like the clutch plates inside your transmission may be slipping. Yes, automatics have small clutch plates between each gear ...

...wont pull, driving on what, pavement, sand, mud, clay, dirt, gravel. and up what a hill , no hill, what>?>???? pull. define the usage of PULL. or does pull mean car will not move, in 2H. ...

...wont be any cable, its a round sensor with a horizontal plug on the end of it. Take a flat head screwdriver and pry the 2 holding prongs off the wiring harnes. then get a #10 socket 1/4in drive with ...