2003 Mitsubishi Outlander "replace ac control switch" Questions

...AC process is being removed from the system. This does not happen at idle and that is because your fan can only remove a portion fo the heat build up. I just had this problem. It might be your fan ...

...replace for my ac compressor? The AC clutch is passenger compartment fuse # 5. This is the fuse for the circuit through the function selector switch to the AC pressure cut off switch & the AC ...

...REPLACE THERMOSTAT.IF ALREADY DONE.CHECK HEATER BLOWER MOTOR SEE IF POWER GOING TO HEATER BLOWER MOTOR.IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR CHECK AC AND HEATER CONTROL FUSE AND ...

Replaced compressor on 2007 Kia Sereno and compressor wont kick on. What's the problem? Please help. ac compressors are controlled by relays , switches , high and low pressure switches and fuses ...

...with dual ac temp switches? If so, the passenger side temp switch is bad. Make sure both switches are in the cold position and try it again. If it is still acting up, simply replace the

...ac are high pressure switch low pressure switch thermostat fan switch compressor relay wires and connections ac clutch coil If it is not working , then there is every possibility that there is no gas ...

AC Control Switch Only Works on High 2001 Voyager Climate Control The AC or Heater Fan Switch only works when set to HIGH. I thought about replacing the climate control unit, but after reading some of

ac vents. Do you think the switch could be bad or something else? If so, could you please tell me the name of the switch and where to find information on replacing it? Thanks James I HAD THE SAME PROB

...ac relay, and put three control heads on my car. The ac will work for a few seconds with each new control head and then stop. Had my thermistor tested and it was proven to be good. My mechanic thinks ...

...a diagnostic machine and it showed that the control switches were bad. Replaced switches...still no heat or AC. Any suggestions? what switches did you replace. sounds like you blend door motor is ...