Question about Nissan Xterra
...knock sensor is located? V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace. Fig. Engine ...
where is the knock sensor located Thank you fo using Fixya For your 01 Nissan xterra V6 3.3L. The sensor is located underneath the air intake manifold on top of the engine block. All the best!
...DTC is a very common problem with Nissan vehicles. On most Nissan vehicles the knock sensor is located on top of the engine block. how to replace the front wheel bearings on a 2004 nissan xterra ...
...knock sensor for my 01 olds aurora with a 4.0 engine bank 1 sensor 1 will be in exhaust manifold by firewall in the middle. bank 1 sensor 2 will be behind convertor .bank 2 sensor 1 will be in the ...
...engine knock sensor located on a 1999 mazda millium Hi, my 01 Mill. noc senser was on top of the motor, but under the intake! needless to say it cost alot... had other stuff done so I can't tell what ...
Question about Toyota Cars & Trucks
engine Toyota camry knock sensor 92-01 you will need a 27 mm wrench to do it so go to sears or another quality tool store to buy a set don't waste your money on the cheap stuff they can strip the head
sensor should be located on the intake manifold by the thermostat house. Once the rise issues has been addressed the check engine light should go off after the the start up. Good luck and keep me
...knock the dust and carbon off. See if that helps improve let me know and we can go from there. I'm guessing fuel pump is going. Check for 40 PSI pressure with fuel pressure gauge. Check in engine ...
...engine that has cylinder #1. Note: This DTC is very similar to P0174, and in fact your vehicle may show both codes at the same time. Symptoms: You will more than likely not notice any drivability ...
697 questions posted
Usually answered in minutes!
568 Questions
522 Questions
289 Questions
263 Questions
259 Questions
