2005 Nissan Altima "2006 crank shaft position" Questions

...Crank position sensors for 2002-2006 Altima's. Check with you dealer before you go doing any repairs. You may discover you can get your car repaired at no charge. NHTSA Campaign ID number :O7V527000 ...

...2006 nissan 2.5 liter engine so can be replaced codes said sensor was bad THE CRANKSHAFT SENSOR IS LOCATED ON THE OIL PAN. The crank shaft sensor is easiest to get at from under the truck, VERY

...crank shaft position sensor A circuit malfunction) code on my 2006 Nissan Altima 4 cylinder--what does that mean? thanks for any help! I am also getting a PO725 code-but I read that it might be ...

location of crank shaft position sensor on 2006 nissan altima its on the back side of the engine near the bell housing   there was a factory recall on some of those

2006 nissan altima bought used 56000 miles. Been having stalling issues for a while now at low speeds, making slow turns or just coming to a stop. I have replaced the fusible link, cam and crank shaft

...crank stalling at a stop the "CS Adv" was stuck at greater than +35. The MCU is dmb and smart at the same time. Never was there an error for timing sensor but I un plugged my suspected sensor ...

...Crank shaft sensor. p 335 is the CRANK shaft position sensor --circuit malfunction-- ===causes wiring---crankshaft position sensor by replacing the CAM shaft position sensor you have replace probably ...

...2006 Mercedes gl450? http://www.mercedesmedic.com/crank-shaft-position-sensor/ ...

...Sentra starting problem I have 2006 Nissan Sentra 1.8L and it is hard to start. I start it but after I turn it off I have to wait for a while to start it again replace the crank shaft position ...

...be l 5.4 3 valve run the fault codes to check which sensor is switched off. It could be a crank position sensor but it could also be a cam shaft position sensor or immobiliser that is non