1999 Mitsubishi Montero "speedometer stop work intermittely" Questions

...speedometer sensor is intermittently working if it does not work at all, the tranny will not shift to 4th gear no matter how hard you push the gas pedal to the limit!! I replaced the speed sensor and ...

...be it. cold corroded connector would conduct better than a hot one. https://www.jaguarforums.com/forum/x-type-x400-14/gauges-speedometer-sometimes-dont-work-97892/ Or the relay could be

speedometer stopped working 2004 chevy blazer speedometer stopped working this vehicle has an electronic speed sensor located on the trans i do believe but im pretty sure this is your problem change ...

...she revs up & down like it's shifting up & down until it warms up. Once it warms up speedometer works & it stops reving. Anyone know what it could be? Side note - why is the ...

Stability control, traction control, ABS, tire pressure sensor, and speedometer are all giving me problems the speedometer stopped working, the traction control keeps kicking in, the stability control

speedometer works intermittently any suggestions? hi, sounds like the vehicle speed sensor mounted on the transmission is going bad or loosing signal. generally, honda speedometers work for life, i've

...speedometer stops working we stop and shut off the vehicle then start it again most of the time the tach and speedometer starts working again. When the gauges quit, does the ABS light come on? Does ...

...speedometer will stop working and odometer and trip meter go to-----sets code po 722 and check engine,traction/abs stability light go off.I replaced output speed sensor but no luck.happens whenever ...

...Speedometer, RPM, Odomoter and Gearshift indicator light work intermittently on recently purchased 1999 Chevrolet Suburban. Sometimes all gauges will work for 2-3 miles then check gauges light comes ...

speedometer works and stops working intermittently. I don't know how to unplug to clean the contacts This vehicle 1990 does not have a digital speedometer correct.? The cable runs from the output ...