...remove motor mount and pickup engine? yes thats correct. in order to remove the motor mount you need to make sure you have a engine hoist to support the load. you might be able use a good floor jack ...
engine and transmission brackets to the bolts. Slide these out. Remove the bolts that attach the mounts to the frame and remove the old mounts. Reverse this procedure using the new mounts, but be sure
.uncouple transmission from engine remove engine mount bolts , take a little more weight with the crane and slide engine clear of transmission , lift clear of car and slide crane clear to engine stand
remove the motor mount you need to make sure you have a engine hoist to support the load. perhaps you might be able use a good floor jack and try to support the motor from the bottom. In any case when
...engine support fixture. Remove or disconnect the following: Torque axis mount Water pump and discard the gasket To install: Fig. 3: Exploded view of the water pump and mounting bolt locations - 3.8L ...
...Remove plastic cover on top of engine to uncover wires going back to ignition coils. Remove plug wire and trace back to coil. Remove and replace spark plugs on at a time, same with wires. Spark plugs ...
...to get to the back side of the engine. Usually there is an engine mount on the left front (Looking at the car) to lossen this allows you to rotate the engin forward to get to the spark plugs
Question about Oldsmobile Aurora
...engine mount bracket. Raise and support vehicle. Turn wheel to the extreme right and remove right side splash shield. Remove belt from crankshaft and A/C compressor pulleys. Twist belt to get between ...
...remove the engine "plenum cover", the "air vacumn chamber" (mounted on top of firewall--2 screws), the "coil packs" with the mounting bracket (just under the air chamber), and then you can access the ...
566 questions posted
Usually answered in minutes!
972 Questions
508 Questions
489 Questions
394 Questions
308 Questions