Question about Mitsubishi Outlander
be like that I diagnose it and am shown p0118 ECT sensor input high, the engine temperature very low Test for stuck relay. With everything off but key on, feel the tops of relays for a warm of hot one
...FANS DO COME ON AND SOMETIMES THEY STAY ON. WHAT ELSE CAN I DO? THANK YOU DANNY Use this thorough testing procedure to troubleshoot this issue. Step1 Check for broken wires or loose connectors around ...
cooling fan on. If test light illuminates, go to step 14). If test light does not illuminate, go to step 15). 12. With jumper wire still connected, disconnect cooling fan harness connector. Using test
...Relays, same scenario. As long as I run with the AC on, the temp stays at 210 on the guage. No leaks, etc, fan is only issue. Chevy dealer says will not come on until temperature reaches 219 f DTC ...
cooling fan motor, connect a test light to the harness from the car (not to the motor side) and run the engine. Watch the temperature gauge and before you the boiling (overheating) the bulb should lit
Question about Cars & Trucks
...relays, and connections and I'm still getting a p0480 code. My a/c gets hot and my car slightly overheats because of it. I just don't know what the next step should be....the vehicle speed sensor or ...
Question about Mitsubishi Outlander
need to find circuit/relay location for cooling fan. fuse is good, fan motor tested fine. need wiring schematic where is the circuit located for a 1994 ford taurus cooling fan? fuse is fine, fan motor
...access to scan tool with bidirectional control to see if you could turn them on that way. you could jump power directly to fan's to see if they work.How to test relay VEHICLE RELAYS Operation ...
Question about Mitsubishi Outlander
test ? Hook up a scan tool to see if the PCM/ECM - engine computer is reading coolant temp. ? Testing not guessing ? Do you even know how the system works . The engine cooling fan system consists of 2
...relays, use the scan tool Relay 2 and 3 command. ? If not the specified value, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM. Install a 3A fused jumper ...
331 questions posted
Usually answered in minutes!
561 Questions
152 Questions
132 Questions
107 Questions
83 Questions