1999 Dodge Dakota "belt tensioner" Questions

...belt over the tensioner pulley-you do this using the 1/2" drive rachet head inserted into that square hole, it provides you with leverage to turn the tensioner far enough to install the belt. The ...

...tensioner housing. If a new belt is being installed, tang must be within approximately 24 mm (.94 inches) of indexing stop. Belt is considered new if it has been used 15 minutes or less. If the above ...

...belt broke- want to replace it YOU HAVE WHATS CALLED A TENSIONER PULLEY IN FRONT OF ENGINE , ONE OF TWO PULLEYS THAT ARE SLICK (NO GROOVES). THE TENSIONER PULLEY IS WHAT YOUR AFTER. IT WILL BE ...

...belt on using the tensioner You do not have to remove anything except the old belt.It routes around the fan pulley.Should be a diagram under the hood on the hood or near the core support.Hope this ...

...tensioner loosening the belt, Remove the old belt and install new one per the routing. Check to make sure the belt is sitting properly in all pulleys ...

...tensioner arms/bolts. Once the belt is removed, replacing it is the reverse process. Hope this helps, and please rate my answer.  need the routing instructions for the serpentine belt for a 1992 ...

...belt tensioner somewhere on the motor. Its on a spring and what it does is push against the belt to keep it on and tight on the pulleys. Either pull it out of the way, or unbolt the tensioner and ...

...tensioner off enough to slip the belt off one of the pulleys. Install in the reverse order using the wrench back the tensioner pulley back enough to get the belt over the last pulley then release the ...

...belt tensioner to provide suffiecient tension...I had to try four different manufacturers before the tensioner was adequately tight with room to grow as the belt naturally stretches from use.). I ...

...belt? Are you sure it has a tensioner? Not ALL vehicles do. Look for a pulley that has an arm attatched to it.(Not bolted directly to the block) There will usually be some sort of marking to measure ...