1999 Dodge Stratus "old mounting plate installing new" Questions

mounting hole in the sensor. NOTE: If the removed sensor is to be reinstalled, clean off the old spacer on the sensor face. A NEW SPACER must be attached to the sensor face before installation. If the

...old seal stayed on the mounting plate and wasn't removed before the new filter was installed, or the mounting plate or seal is defective. So check and see and let me know how you made out.

...old flywheel had 2 or 3 marks on it, new one has nothing distinctive to match with! clutch assy.has paint mark on it. should that line up with the crank dowl pin? The clutch disk and pressure plate ...

...ignition switch not moving from start to run position, I presume new solenoid on starter..if not or firewall mounted replace, was there a shim plate on old starter that was left off on new install

...old gasket material and corrosion. To install: Along with a new gasket, install the water pump on the engine block. Tighten the water pump mounting bolts to 88-115 inch lbs. (10-13 Nm). On 1.3L and ...

...old belt out and the new one in. When putting the plate back on the mount do not use an impact gun because the bolts will break. ...

...plate the mirror is attached to pops out of the holder? If it does, it would make it easier to fit the new glass on the bench. I don't want to force it unless I'm sure. Thanks in advance, Frank Just ...

...plate bolts and torque them to 20 ft lbs. Remove the centering/alignment tool after you've bolted it together Remove old Throw Out bearing from input shaft on the transmission and slide the new ...

...mounting screws, and pull the unit out untill you can get to the retainers. Remove the old knob, and install the new one. Reverse the above sequence and reassemble. When reinstalling, make sure that ...

OLD TRANS. AFTER ALL WIRING IS DISCONNECTED REMOVE TORQUE CONVERTER PLATE TO REMOVE TORQUE CONVERTER BOLTS...OR SOME CAN BE REMOVED FROM STARTER LOCATION. REMOVE ANY ENGINE COMPONENTS/RADIATOR/COOLING