1999 Dodge Stratus "remove replace crank sensor 12" Questions

Ad

remove magnet. Instalation The target magnet has locating dowels that fit into machined locating holes in the end of the camshaft. - Install target magnet in end of camshaft. Tighten mounting screw to

Ad

...12 volt meter hook it up after you charge the battery. Leave the lights on for about 3 minutes. Then shut them off. Then look at the voltage cranking. If it drops below 11v you have a bad battery. A ...

Ad

...Remove the 4 pin electrical connector from the coil. one of the terminals is a 5 volt feed. Connect the light to that terminal and clip the other to ground. Turn the key to the on position. the light ...

remove the distributor assembly and reconnect the plug to the crank angle sensor. Peel back the insulation sufficiently to connect a voltmeter to the wires. Ground the coil high tension wire. With the

Question about Dodge Stratus

1 Answer

...remove the belt. You'll need to recompress the hydraulic (auto) tensioner in a vise and insert a retaining pin through the pin-holes at the top (through the tensioner piston) to keep it compressed ...

...belt cam and crank sensor,but will not start,no fire to coils,getting 12 volts,removed belt and started over same thing, Check your relays, Kias are very picky about that and only use Kia

Question about Dodge Stratus

1 Answer

Replace the timing belt???Also one last thing about when I purchased the 2 sensors, there was something about a paper spacer and no-one seams to know what this is about the paper spacer? Could it have

Question about Dodge Stratus

1 Answer

...crank sensor and modules hows it goin sounds like u been havin fun with this one have checked for wolts at the module should be 12 with key on if so check for crank signal while cranking should be ...

Question about Dodge Stratus

1 Answer

...crank sensor is located on the back side of the engine block towards the transmission. If you remove the 2.5 engine cover you will be able to see it better. Look down near cylinder 4 intake runner at ...

...remove and inspect crank sensor on the transmission side of the engine ( on engine below thermostat housing bolted to engine block) once i removed it i noticed the tip of the sensor was broken, yes, ...

Not finding what you are looking for?
1999 Dodge Stratus Logo

661 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2004 Dodge Stratus
2004 Dodge Stratus

1,390 Questions

2001 Dodge Stratus
2001 Dodge Stratus

1,094 Questions

2002 Dodge Stratus
2002 Dodge Stratus

901 Questions

2000 Dodge Stratus
2000 Dodge Stratus

752 Questions

2006 Dodge Stratus
2006 Dodge Stratus

606 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...