...nut for the CV axle to hub it is 180 ftlbs 120 ft lbs A torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact for the hub to axle application. If you don39;t use a ...
Question about Dodge Neon
...axle nut on it, please and thank you. 160 ft lbs 2007 Yaris axle nut torque pdf" the torque is 160 ft pounds for the axle nut. Last edited by GrayYaris; 04-23-2014 at 08:39 AM.Apr 22, 2014 Torque ...
...axle nut. You can put a punch in the fins of the rotor to keep the assembly from turning while you rmove the nut. You can can do the same thing when you torque the axle nut. 3. Remove the caliper and ...
Question about Dodge Neon
axle bearings. Not sure if I over tightened or not (lock nut). I wasn39;t sure. Does an I just replaced the rotors on my GMC Sierra 3500HD 4x4 duelly. I am picking up a sound on the driver side rear
...axle nut. Put a punch in the fins of the rotor to keep the hub from spinning. Remove the caliper and the rotor. Unplu the abs harness. Remove the three bolts that hold the hub to the knuckle. Remove ...
Question about Saturn Cars & Trucks
...axle nut if it39;s an all wheel drive (it is important to tighten the axle nut to the proper spec after replacing the bearing. Failure to properly torques the bearing will result in premature ...
...axle nut. - I like to remove the outer tie rod end from the knuckle. This makes it easier to get at the caliper bracket bolts and the wheel hub bolts - remove the caliper and the rotor - unplug the ...
...axle nut to hub on 2000 Plymouth Neon Yes there is a torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact for the hub to axle application. If you don39;t use a ...
...axle nut to hub on front end of 2000 Plymouth Neon have to be torqued to specs to not harm bearing to Yes, a torque spec of 180 foot lbs. is recommended. I highly suggest never using an impact ...
941 questions posted
Usually answered in minutes!
861 Questions
762 Questions
743 Questions
710 Questions
544 Questions