power side of the fuse should be the one that has two wires hooked up to it. Hi, you problem need to have your multi function switch checked all your brake lights and turn signals is grounded Thur it.
...power wire directly to fan for testing purposes) then as a temporary measure you wire a switch to Control thr relay(relay actually handles the fan current). find the fan relay. it should have 5 pins. ...
...steering column. Check the solid yellow wire for power when the key is in the start position. If there is no power, the ignition switch is bad. The solenoid is not engaging the starter. Most likely ...
Question about Dodge Caravan
...power tilt steering has no power A control module ! Electronics The steering column has a tilt/telescoping control system that consists of an electronic control module capable of class 2 serial data ...
...Power Steering Pressure Switch Circuit How do i fix the check engine light on my mazda 626 2001, p1652 Power Steering Pressure Switch Circuit? to cancel the check engine light disconnect the battery ...
...power steering pressure switch circuit failure. Power steering pressure switch.when turning put's load on engine so what p/s switch does give's more power to engine so it wont die out, same as a/c ...
...power supply to be depleted. Remove the steering wheel (3600). Refer to Section 11-04 for the removal procedure. Remove the four screws from the lower steering column shroud (3530). Remove the ...
Question about Mercedes-Benz Cars & Trucks
...power steering circuit or the rack is a pressure switch and this switch is either disconnected or faulty ,look on the pump and the high pressure feed pipe and if not found look on the rack by the ...
...or controls the circuit? i would have to say to check for a relay in your fuse boxes for power steering pressre switch or it may have its own police pkgs have a lot of relays due to all the ...
Question about Dodge Caravan
...Power Distribution Center (PDC) . Check for continuity between the steering column half of the horn switch feed wire connector and a good ground. There should be no continuity If OK, go to Step 3. If ...
1,334 questions posted
Usually answered in minutes!
2,271 Questions
1,496 Questions
1,337 Questions
1,299 Questions
1,150 Questions