2001 Oldsmobile Alero "blower motor resistor" Questions

blower motor fan is controlled by the blower motor resistor.Its the resistor which controls the fan on respective speed which you select.But if the resistor goes faulty,then it will not be able to set

...blower motor and fan are located in the lower right hand corner of the HVAC module. Remove the right closeout/panel insulator to access the blower. The blower motor resistor is the part where the ...

...blower motor does not work,,, check fuses, didnt check blower resistor, CHECK BLOWER MOTOR RELAY ALSO, AND USE A TEST LIGHT TO SEE IF POWER GOING TO BLOWER MOTOR, IF YES BLOWER MOTOR FAULTY.IF NO ...

...blower motor goes through the resistor, to slow the speed of the blower motor down. When the high speed is selected, the resistor is bypassed, and full current is passed to the blower. I believe the ...

...blower motor is under the right side of the dash remove the hush pannel you don't have to remove the blower motor but it does give you more room disconnect the wiring to the resistor there are two ...

blower motor,ran 12v direct to the motor, it works fine, don't see any scorch marks on the resistor. when i turn on the blower switch on the dash i can hear an audible click, as well as when i turn it

...blower motor and checked fuses and still nothing.The heat and air are working fine just not blowing. I replaced the blower a year ago and now again Its either a bad connection on the blower motor ...

...blower motor resistor. To get to the blower resistor you must take off the modesty panel that hides all the wiring. The right side of this panel (to the right of the courtesy lamp) just swings out of ...

...blower motor resistor is bad.It is located on the passengers side by the blower motor.You will need to replace it.Just follow the blower motor noise when is is on and you will find the resistor very ...

...blower motor resistor located near blower motor in heater box has burned. suggest new resistor card I replaced the blower motor resister and the heater control unit and it still only blowes on hight ...