2001 Chevrolet S-10 "s10 axle removal" Questions

Ad

...s10 blazer No "axle pins". Axles are held in with "c" clips. Remove wheels. Remove drums (or rotors). Remove differential cover. Rotate axles or driveshaft until a small bolt running horizontally can ...

Ad

...S10 2wd Rear Axle repair - what do I have to do to remove the carrier bearing? In general you have to drain the rear end, remove the cover, remove the carrier pin, remove the axles, then remove the ...

Ad

...S10 with a 2.2L WITHOUT pulling the whole motor? Remove motor mount bolts and rear transmission crossmember bolts or nuts,suppport engine/trans. see if u have enough clearance between pan and axle ...

...s10 2.8l 4x4 four speed in order to get the oil pan off of a 4 w/d model the front axle assy must be removed first then oil pan removal is straight forward after that. cv axles can be left in just ...

...s10 chevy pickup truck? I have all the outter stuff removed just need help removing the inner part tranmissionn side. You have to remove the differential cover by removing the bolts, draining the ...

Question about Chevrolet S 10

1 Answer

...s10 with a 4.3. i threw the rod bearings and i need to get the oil pan out and to do that i need to get the front differential out... i have all the bolts of and the right half shaft and the front ...

...of the Chevy s10 by removing motor mount bolts and transmission crossmember bolts? You may have to remove the cross member & also drop the front axle some, if you have 4 wheel drive,for

Question about Chevrolet S 10

1 Answer

s10 how to replace front axles Halfshafts (Drive Axle) REMOVAL & INSTALLATION Fig. 1: A torn CV-boot requires removal of the driveshaft for overhaul Fig. 2: On most vehicles. the caliper should be

...s10 4x4 zr2? My skill level is basic, I do the oil changes and tune-ups on my truck but not to much more. It is a ''Do-ItYourSelf'' jobs or is the maybe beond my skill level? Thanks for any advice or ...

Question about Chevrolet S 10

1 Answer

how do you check or add fluid to the rear axle of a s10 4x4 plug on right side of the housing near the driveshaft yoke.Remove plug with 3/8 ratchet,fill to bottom of hole

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

934 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...