2002 Chevrolet Avalanche "engine control module location" Questions

02 avalanche 5.3 code po327 just change knocks sensors and wires n light is back on locate and replace ecm module(engine control module) Have not got data for your model for location

...control module have to build speed in 1st gear when rpm goes past 2 the engine rebs high but no acceleration is it the transmission module or should i replace the whole trans check fluid level and ...

where is the POWER CONTROL MODULE located location Its in the engine compartment above the frame rail right next to the battery.

...control module located on a 02 chevy avalanche ? The abs motor runs constantly when the engine is turned off. Had to remove the abs fuse to make stop running. THE EBCM IS BAD this is the electronic ...

...engine crank sensor. Electronic Control Module provides initial timing for start then depends on the crank sensor once started for timing and firing it could also be the body computer located under ...

...control module. Something inside this module goes bad and the result is a blower motor that keeps running at times even though the engine is off and the key is out of the ignition. The module isn't ...

...engine control system requires service. The control module monitors the MIL control circuit for conditions that are incorrect for the commanded state of the MIL. For example, a failure condition ...

...Control, and then tthe engine warning light work on. Also, when appears this message, there is a strange shcok in the trasmission, in fact for this problem after 55.000 miles, I have just change one ...

...engine must be running for the heated seat feature to work. The heated seats will shut off automatically when the ignition is turned off.Two buttons, located on the door, are used to control the ...

...engine room)] ? to BCM (body control module) terminal 42 ? through 10A fuse [No. 19, located in the fuse block (J/B)] ? to combination meter terminal 24. With the ignition switch in the ON or START ...