2005 Chevrolet Express "adjust timing idle speed chevy" Questions

...adjust the idle speed, it is computer controlled, if there is a problem then you must clean or replace the idle speed control valve and the throttle valve (clean only), final idle speed with a clean ...

...to miss. Back out the idle mixture screw 1/4 turn. Repeat procedure for the left hand idle mixture screw. Adjust idle speed screw to 800 RPM for auto trans in gear or 700 rpm manual trans in

...timing and can reduce idle some, but at 13-14 has no power ..The engine cuts out occasionally. Tried all the tips for checking for leaks around throttle body... no change in engine idling. No check ...

adjust the timing as everytime I try it goes wild. The EGR valve, Idle Air Valve, Ignition Control Module, spark plugs, plug wires, coil,TBI rebuilt,Knock sensor, O2 sensor have all been replaced. I'm

...adjust the timing, holding it by the body and not the cap. Turn the distributor in the direction of rotor rotation to ******, and against the direction of rotation to advance. Tighten the locknut. ...

...idle. This happened suddenly after turning into a parking lot. Could my steering pump be going out? first check the condition and level of p/s fluid. if low top off first and turn your steering wheel ...

...will sort out the timing/mix for the whole rev range/road load/speed. all you can do at home is idle/timing settings for tickover. find a specialist tuning/race builder local to you (im in the

...then confirm the speed of 750, or fine adjust UP or DOWN, until that recording is consistant. You should then have no problems. Regards, DT the idle should be around 600-800 rpm's when in ...

...adjust the timing: Warm up the engine to normal operating temperature. Stop the engine and connect the timing light to the No. 1 (left front on V8, front on six) spark plug wire. Numbering is ...

timing with the car in gear with the idle screw backed out once i had it set to where the car idled great i would then turn the idle screw in till it barely touched Hope this helps you msbigdog7@yahoo