...39;ve never done business before and all assumptions are off the table. For an engine - make that any engine and irrespective of manufacturer - to run, you need three things to happen inside the ...
...39;+ 39;ignition harness 39; 39; STARTER 39;red/gray 39;+ 39;ignition harness 39; 39; IGNITION 39;black 39;+ 39;ignition harness 39; 39; ACCESSORY 39;black/red 39;+ ...
...39;s ignition module. My recollection is the two screws attaching it to the distributor are odd-ball 7/32 in. size. If the module is taken off, use special ford di-electric grease on the ...
...39;s usually best to replace the entire distributor on your Accord, to resolve a bad ignition module. Mark the distributor position ,remove the bolt cap,and wiring ,remove from motor to make the job ...
...39;t start. Please help us!!THANK YOU The ignition module should be mounted on the side of the distributor.You would need to check to see if the module is getting power from the key, and if the ...
39;t blow, reconnect the ignition module and turn the key on again. If the fuse blows, you know the ignition is bad. If not, plug in the sensors one at a time to see which one is shorted. The location
...39;t locate where the spark plugs are for a 2006 saturn vue,4cy.Could you tell me where they are located? They are located in the head.To gain access you need to remove the cover on top of the engine ...
ignition control module, located, I think, on the firewall driver39;s side. Did you check for codes by jumping "t" and "e1" on your little diagnostic connector(same location as igniter-lift cover on
1995 Honda Civic 1.6 Ignition Control Module Location Car won39;t start The module should be in the distributor.
39;t hear fuel pump when ignition is turned on, replaced fuel pump and filter, still not able to hear fuel pump...what else could it be? Do you have power and ground to the wire harness that feeds the
340 questions posted
Usually answered in minutes!
14 Questions
248 Questions
219 Questions
204 Questions
185 Questions