1994 Oldsmobile 88 "lb ft inch" Questions

6) Ft/Lbs Step 3: 12 Ft/Lbs torque intake plenum: Step 1: 24 inch/lb (hand tight) Step 2: 48 inch/lb (4) Ft/Lbs Step 3: 84 inch/lb (7) Ft/Lbs (To torque bolts, start in center using crisscross pattern

...Lb-Ft = 1.35582 Nm. The direct quote: boltscience.com Torque is a measure of how much twisting is applied to a fastener. The units used to measure torque are in the form of force times length. The ...

...lbs to ft lbs divid by 12 1 ft lb = 12 in lbs Easy peasy, 12 inch-lbs is 1 ft-lb, sooo! 72 inch lbs is 6 ft-lbs and 41 inch-lbs is about 3.5 ft-lbs. Basically 72 is just hand tight and 41 is snug

...Bolts all step 1 = 88-98 Nm, 65-72 lb.ft 147 mm, 5.8 inch bolts step 2 = 85-95° 119 mm, 4.7 inch bolts step 2 = 70-80° Cylinder head Sub Bolts step 1 = 34 Nm, 25 lb.ft step 2 = 44-54 Nm, 33-40 ...

...lower intake manifold bolts (two on each end) to 25 Nm (18 lb ft). Upper Intake Manifold Tighten Bolt/stud 25 Nm (18 ft. lbs) Notice inch pounds and foot pounds. 62 inch pounds is 5.2 foot

...70-85 ft lb Ring gear bolts 70-85 ft lb Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in The rear end axle nut torque ratio for a 2018 Jeep ...

...lb ft). rocker arms 14 N.m (124 lb. in.) plus 30 2.2L Engine & 2.4L Engines These engines are not equipped with rocker arms. The camshafts directly actuate the valves. 3.1L Engine & 3.4L ...

...ft-lb * Rear band adjustment locknut - 25 ft-lb * Transmission pan bolts - 13 ft-lb I just replaced the solenoid with the recommended transducer and all is fine now. The transducer cost me about $50 ...

...ft lb for the pulley bolts. i have a 1996 olds sedan,cant find bolts for power steering pump to replace water pump,need picture If you have a front mounted engine mount, you must support the engine ...

lb?ft).:{132inch POUNDS LB}

best is keep the foot lb wreck in the drawer.
or will snap off all the bolts easy.

48 steps to back on,.

RTM HERE


https://eautorepair.net