1999 Chevrolet Silverado 1500 "rough shifting" Questions

2001 silverado transmission shift rough 1 out of 30 times i start the truck and put it in drive it will not shift properly, I went to the dealer and they told there was a code on the reader for a ...

...no reverse shifting from n to rev and park torev when shifting from rev to park werring sound stops same shifting to neutral inow have no reverse and drive shifts rough Time for a rebuilt of the ...

...rough. shifting is hard and barely pulls itself up hill. just replace intake gaskets last week Try taking the positive battery cable loose for 2 or 3 minutes, this will allow the computer to reset. ...

rough-idlestaling-and-erratic-shifting.html ----------- While stop engine idles like cylinder missing? http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html --------

My 2001 chevy truck transmission shifts rough in 2nd and 3rd gear when I drive about 50 miles or more, when driving less. it shifts normal. I cannot figure it out. Please help you should have scanned ...

to 55 MPH Cruising at a steady speed the engine surges. At a stop there is no surge, does not shift rough, and all gears are present. sounds a little like a cruise control problem. they used to have a

...rough shifting on 2nd and 3rd gear. it seem when the transmission is hot like when I travel over 100 miles or more. it shifts normally otherwise. Thanks I had the same problem on my 2000 Chev ...

Harsh shift, Acceleration hesitation, Rough idle I have a 2008 Chevrolet Silverado 2WD, 4.8L V8, 4A, LT1 w/ 4 dr extended cab, with 23K miles. I get an occasional harsh shift from 2nd to 3rd, usually ...

...rough shifting problem from 2-3 and 3-2 since new. There was a service bulletin declaring it a "non problem" but it is still annoying as he//. Can anything be done? If replaced which trans would you ...

...rough and late shifting between all gears. After driving around 10 miles, I realized something was seriously wrong. I decided to crack open the oil pan again and check to make sure the filter was ...