1998 Pontiac Sunfire "2 crank sensor" Questions

...are 2.2 the crank sensors are different wiring the 96 has three wires leading to it and the 97 has only 2 can I swap crank sensors As long as the 96 one looks the same as the 97 and fits

...crank shaft sensor is located. The Crankshaft Position Sensor is located under hood, center, rear engine area, mounted onpassenger side rear of cylinder head.Fig. 2: View of the Crankshaft Position ...

2 minutes then every time i start it it stalls sooner i replaced the fuel pump and filter no codes are showing any ideas This is most likely your crank position sensor.... it sits behind your harmonic

...time that doesn't result in repair. I have had that happen before,Mine was crank sensor.The three things i know that would cause that problem.#1 crank sensor #2 cam sensor #3 module plate under

I have a 2000 Sunfire and it is running on 2 cyclinders,I have replaced coil packs and still runs the same. check the crank and cam position sensors

i changed the fuel filter . the car just will not stay running? if it will run for just 1 or 2 seconds then replace the crank position sensor

have little to no spark on number 2 and 3 cylinders changed coil same problem any sugestions? Change the crank sensor, its on the back of the engine.

1996 sunfire 2'4 wont start the car wont start Battery could be dead. If not then the ground wire could be loose or corroded. Fly wheel could be worn. Crank shaft position sensor could be bad.

crank but no fire to plugs what the problem with the spark new plug Ignition module maybe or crankshaft position sensor . Videos on youtube showing how to diagnose GM ignition system for your vehicle