5 hours already by the time i go down to move around 3:00 it show me wheter or not their is a leak. Ms Jinks. This is prob not a gas cap. Its prob a vent control valve\ purge solenoid that has failed.
...5 volt range and then turn on the Check Engine Light which will stay illuminated until turned off by an appropriate scanner. The Dealership employs a DRB III to do this. So in essence, you have NO ...
...5. The thermostat has a top and a bottom. If you look closely, you will see a place in the outer parameter of the thermostat where there is a small hole, often with a little metal tab which projects ...
...5-3.2 Nm (23-28 Lb-In) Installation Route the vacuum supply hose through the dash panel and seat the grommet in the opening. Position the heater air plenum chamber under the instrument panel with the ...
...00 water temp gauge Hi, My water temperature suddenly went up all the way to the right as I was driving on the freeway today and started alarming, as I started driving slower it went back to the ...
...00 for procedure. Position new head gaskets onto cylinder block (6010) using cylinder head to block dowels (6A008) for alignment. Head Gasket Position cylinder heads onto cylinder block . CAUTION: ...
453 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
294 Questions
301 Questions