...is leaking and to replace it you will need to remove transmission from vehicle. while your there you should change the clutch because it is out. unless it was just change then just the slave. good ...
clutch slave cylinder reservoir. I guess my big question is, do I need to get this trans rebuilt because of synchros being bad on 2nd gear? It sounds as though either the throw out bearing or pressure
clutch pedal? How do I remove it so I can replace it? there should be two bolts/nut that hold the master cylinder. look under the dash on top of the clutch pedal could be the slave cylinder. mine went
slave cylinder bleeder is closed. Have someone pump the clutch pedal fully down and while allowing it to come fully up about 20 times and then hold down. Now with the clutch held down ........open the
...replace the clutch. Also it would not hurt to check your transmission fluid or better yet service it to replace the oil transmission fluid with new fluid. You'll find the fill and drain bolt at the ...
clutch kit, slave and master cylinder, flywheel... If you can see the slave cylinder actuate, then have someone push the clutch down and watch for movement. You should see the release lever move
Question about Chevrolet S 10
...clutch pedal with a hose? and can it be replaced and if so ,how? The part on the bell housing is the slave cylinder, the part that connects to the brake pedal is the master cylinder.Check with your ...
replace clutch slave cylinder S10 89 2.5 standard I would not replace clutch slave, take my advice and replace the master and slave unit. Though for the moment this is more expensive, unless you have ...
...clutch plate. I thought an s10 had a slave cylinder ? if so you need to check the fluid near your brake cylinder for your hydraulic clutch and you will have to bleed the air out of it down near the ...
1,037 questions posted
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
686 Questions
620 Questions