1990 Dodge Dakota "pressure plate located" Questions

Ad

Question about Dodge Dakota

2 Answers

...pressure plate) and maybe the thrust bearing, Regards John If you have no free travel in your clutch pedal it may be your clutch and or pressure plate If you have no pressure in your clutch pedal it ...

Ad

...pressure plate/throw-out bearing - truck ran when I started, but won't start now. Have replaced clutch sensor/switch in transmission - can't figure anything out - any thoughts? 98 Dodge Dakota Have ...

Ad

...plate in the distributor. As the engin turns the send refernece pulses to the computer which grounds and ungrounds the ignition coil causing it to discharge and send voltager from the secondary coil ...

pressure plate mounting bolts from the flywheel. Remove the pressure plate and clutch disc. To Install: Insert a clutch disc alignment tool through the disc splines and into the flywheel pilot bearing

Question about Cars & Trucks

1 Answer

...pressure plate location Part of the clutch, it is bolted to the flywheel. The clutch disc is sandwiched between the pressure plate and the flywheel. Once the transmission or transaxle is removed, the ...

Question about Dodge Dakota

1 Answer

...plate or in the owner's manual. There is not a lot of variation in the tire pressure between different automobiles, although some trucks and SUVs use lower tire pressures for off-road operation. The ...

...pressure plate. BAD Slave Cylinder! BAD!!! - YouTube ? 2:01 www.youtube.com/watch?v=V8ttEEfmjpQ May 26, 2011 - Uploaded by wwjoshdew So depending on how good the clutch is, I will PROBABLY just ...

Question about Dodge Dakota

1 Answer

...pressure plate ring lower transmission. remove pressure plate evenly and slowly Then you inspect for wear on the pilot bushing the input shaft rests on, the friction disc is assumed to be too thin, ...

...plate.Be sure to relieve fuel line pressure and use a brass strike to remove the retaining ring. Either under the rear seat or under the trunk's floor pads, you should find a metal plate with wires ...

...and in front of the tire, you have to remove a protective plate to get at the low pressure switch. It is possible to reach this without jacking the car up, but it would probably be easier if you

Not finding what you are looking for?
1990 Dodge Dakota Logo

377 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Dodge Dakota
2001 Dodge Dakota

1,021 Questions

1998 Dodge Dakota
1998 Dodge Dakota

870 Questions

1997 Dodge Dakota
1997 Dodge Dakota

712 Questions

1995 Dodge Dakota
1995 Dodge Dakota

723 Questions

1992 Dodge Dakota
1992 Dodge Dakota

618 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...