2000 Ford Taurus "cause rpm high idle" Questions

...RPM for more than a few seconds you have a problem. It is probably the iac (idle air control) valve. it will cause a high idle, if you put it in drive and let off brake n it takes off fast thats what ...

...High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html ------- Vehicle stumbling at idle and shows code 54? ...

...rpm and dies easily. once it moves its fine, but if it stops it dies very quickly. it also revs on its own. if u have no check engine light do the following procedure. Here is the common cause of ...

High rpm The rpm's are running high. After the auto trany shifts 2 times, the 3rd time is about 45mph, however the tack doesn't drop but a little, by the time the vehicle hits 60mph the tack is at ...

...cause by a lot of components. Dirty air filter Dirty injectors + o-rings Vacuum leak at intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start ...

...high rpm self test failed .. the computer couldnt control the speed .. this usuallly indicates that the IAC valve is bad (idle air control valve) .. it could also be caused by the throttle llinkage ...

RPM(yes, the belt is new too, and the Ignition control module.) I'm thinking possibly fuel pump, filter, or injector. Has anybody had these symptoms, I'm ready to tear my hair out!!! I want u to clean

...high enough according to your computer's programming parameters. Many times this shows up in colder weather as you try and start your vehicle. It will usually die unless you put your foot on the gas ...

...cause this high rpm problem.Take it off and try cleaning the carbon out of it so that the piston sits flush in its seat then reset the computer by disconnecting the ground cable on the battery for 30 ...

...Rpm's stay high until I brake for a minute and then it drops suuddenly. Could be a vac leak or a problem with the idle air control valve. I would check the valve to see if it is sticking open. Could ...