2004 Ford F250 "wont suck water" Questions

Ad

...water turn off switch 1/2 way along the block before it goes into the fire wall and should work on vacuum,and opens up when switched to Hot but quite often not being used to often the pipe sucks in ...

Ad

...water and flooded out now wont start just click click all electrical works may have sucked water up in air box,check to see if air filter box has water in it,if so you may have ruined the engine,if ...

Ad

...black is gas. bluish is oil. not losing water after 500 miles? if you are just driving a moile or so you wont see your water level going down,,, no sense retorquing anything after 2

...wont start. Put code reader on it and it said there was no codes Try a new fuel filter. you most likely sucked up some junk or maybe water from the tank when it ran out. Check fuel pump make sure it ...

...wont pull water in and short the pump out at the dealer they have a problem with them sucking water into pump and rusting it comes with new hoses that relocate the inlet side of the air pump nere the ...

water If it wont crank the engine then its probable that water has gotten into the starter or engine fuse bay and and damaged either of these. You can try leaving the hood open for a day or two to let

wont start when its damp outside start fine when air is dry ever get a tuneup this decade?> the spark wires are bad. oldest issues on earth. this. bad ignition. tuneup time. full,. do the 60k, mile

Question about Ford F-250

2 Answers

...wont then its possible it may have sucked up water into the cylinder.pull the plugs and try to turn the motor over.if it does then this is the problem.if you mean it won`t start then let it dry still ...

Question about Ford F-250

3 Answers

...wont start on a side note it died going in a flooded area and has not started since. Not sure where or what to check on things that could have gotten wet. easiest: is the battery good? not so easy: ...

Question about Ford F-250

1 Answer

...stop running water came in an now it wont start you could have sucked water into the engine and welded the pistons to the positions that they were in best way to check would b to take the engine ...

Not finding what you are looking for?
2004 Ford F250 Logo

655 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...