2006 Chevrolet Equinox "remove replace blower fan" Questions

...remove the wiring harness and take out the motor. Theres ways to test to see if it is the motor thats bad, but it requires a multimeter and some familiarity of where you're poking around. A new one ...

...remove the entire dash panel to get to the heater fan blower motor. It should be in the middle or under the glove box, should be located in a plastic box that has like a bell shape to where the motor ...

...remove the electrical connector. It has 2 terminals. One is ground and the other is positive. Test for voltage with key on and fan setting at high. You should see battery voltage. Next do the same ...

...replace? here are the instructions for fan blower removal. remove lower right dash insulator panel from under glove box. slide the body control module aside for access to the blower motor.( bcm ). ...

REPLACE IT. BLOWER MOTOR RESISTOR Removal & Installation Disconnect negative battery cable. Remove right lower instrument panel insulator panel. Disconnect blower resistor connector located behind

remove the blower and hotwire it to the battery to see if it works. If not, replace the blower. Then run continuity tests on the swoitch and replace switch if bad. If you have questions, please let me

...remove the blower motor from the vehicle. If the blower motor fan (also called a 'squirrel cage') must be replaced, use the following procedure: NOTE Do not hammer on the motor to remove or install ...

...Blower now runs normally, with fan speed switch able to adjust blower speed, but of course A/C doesn't work now. THE FAN BLOWER RELAY IN STUCK CLOSE POSITION.YOU HAVE TO REPLACE FAN BLOWER

replace blower fan relay Where is the blower fan relay at? The blower continues to run after the key is removed and to turn it off is possiable by removing the 30A MaxiFuse on the power control center

...replace a blower motor on a 99 oldsmobile cutlass remove lower right dash insulator panal from beneath glove box. slide bcm aside to get to blower. remove the three screws holding the blower motor, ...